10
7. Troubleshooting
WARNING
Before replacing parts, be sure to disconnect the AC adapter plug from the power outlet.
No operation even if power switch is
turned ON.
Is the AC adapter
or connection cord
disconnected?
Connect.
The pass range indicator LED does
not light.
Is the DIP switch setting
wrong?
Set ON or OFF while referring
to the DIP switch setting
table.
The buzzer just sounds 3 times and
the pass/fail result is not output.
Did you move your hand
away from the pad quickly?
Do no move your hand away
from the pad until "PASS" or
"FAIL" is finalized.
The result of daily inspection is NG.
Is the connection cord plug
firmly inserted?
Firmly insert.
The "PASS" and "FAIL" LEDs blink.
Is the connecting cable
firmly inserted?
Firmly insert, and turn the
power OFF then back ON
again.
When other problems occur or performing the above remedies does not resolve a problem, contact
your nearest agent.
To Next Page
Loading...
