HAKO Citymaster 1650 User Manual

Cleaning technology • Municipal technology
Short instructions for Citymaster 1650
88-10-319-4037-0
Hako GmbH - Head Office - Hamburger Str. 209-239 - 23843 Bad Oldesloe, Germany
Tel. +49 4531 806-0 - Fax +49 4531 806-338
A
B
1. Removing the locking shackle  Page 84
Caution: Risk of crushing!
Hydraulic oil specification: HVLP 46
Storage location: Bolt A with split pin
3. Checking the engine oil level  Page 85
Caution: Risk of scalding!
Engine oil specification: ACEA E6 (Low SAPS)
Note: Switch on the battery isolating switch (optional) B.
2. Checking the fuel supply  Page 85
Caution: Risk of fire!
Fuel specification: Diesel (EN 590)
4. Checking the hydraulic oil level  Page 85
Caution: Risk of crushing!
Hydraulic oil specification: HVLP 46
Before start-up of the vehicle
Safety information
These short instructions may be used only in conjunction with the original operating manual!
All cross-references refer to the pages in the CM 1650 operating manual.
Please observe the safety information in the operating manual, as from page 11!
Information about special risks, as from page 16! The vehicle may be put into operation only by trained
personnel!

HAKO Citymaster 1650 Specifications

General

Model	Citymaster 1650
Category	Cleaning Equipment
Drive	Hydrostatic
Travel Speed	up to 40 km/h
Noise Level	72 dB(A)
Width	1320 mm

Summary

Before Start-up Checks

Remove Locking Shackle

Procedure for removing the locking shackle, including caution for crushing risk.

Check Fuel Supply

Procedure for checking fuel supply, noting fire risk and fuel specification.

Check Engine Oil Level

Procedure for checking engine oil level, noting scalding risk and oil specification.

Check Hydraulic Oil Level

Procedure for checking hydraulic oil level, noting crushing risk and oil specification.

Check Coolant Level

Procedure for checking coolant level, noting scalding risk and coolant specification.

Check Tyre Pressure

Information on checking tyre pressure for standard tyres.

Driving Operation

Prepare for Driving

Start Engine

Start Transport Mode

Park Vehicle

Vacuum Sweeping System Operation

Install Vacuum Sweeping System