This pump is designed to be submerged during operation for
proper function and cooling. Never operate this pump without
it being fully submerged in fresh-water only.
Never pick up pump by, remove, or put stress on the cord.
Never operate this pump connected to any voltage other than
that shown on the pump.
Never place your hand, or any object, in or near the inlet
opening while this equipment is operating. If pump inlet is
clogged, always turn off the power supply first and wait until
motor is completely stopped before removing any clogged
material.
Never operate this pump in a swimming pool or in a marina
area.
Never leave children unattended around this pump while
operating.
The pump has a built-in thermal overload trip which prevents
the pump from overheating. Never restart the pump before
letting the pump cool down.
Always have this pump connected to properly grounded
GFCI electrical outlet.
Always disconnect from electrical supply before handling
pump.
Remember, Correct Installation Is Your Responsibility!
Make sure you have the proper installation conditions. The Variable Flow Series Submersible Water Pump needs to be protected
from any objects/debris during operation. Before beginning assembly or operation of product, make sure all parts are present.
If any part of your Variable Flow Series Submersible Water Pump is missing or damaged, do not attempt to assemble, install, or
operate.
Plumbing
For maximum water flow, it is recommended that the largest tubing size
for your pump is used during your installation. Selecting the correct
tubing for your project is crucial for the durability of the installation.
We highly recommend using our Freeze Flex tubing!
Freeze Flex is ideal for ponds and waterfalls requiring quality high-
strength flexible tubing that resists kinking and collapsing.
Refer to the Variable Flow Series Submersible Water Pump Model
Chart for proper hose size recommendations depending on your
model.
To Next Page
Loading...