1. With this function, the computer will record the maximum speed
you reach during riding.
2. Whenever you reset the computer or change the battery, the
max. speed record will be cleared.
1. With this function, the computer will display your average speed
during riding.
2. Whenever you reset the computer or change the battery, the
average speed record will be cleared.
3. It'll display "0.0" if the riding time is below 6 seconds.
4. It's updated every second on condition that the riding time is
over 6 seconds.
5. The computer will automatically reset the following data to zero
once the RTM is over 100 hours or the DST is over 1000KM (or
miles):
RTM (riding time), DST (trip distance), AVG (average speed.)
1. DST refers to the accumulated distance during a trip.
2. Whenever you reset the computer or change the battery, the trip
distance record will be cleared.
1. RTM refers to the accumulated riding time of a trip.
2. Whenever you reset the computer or change the battery, the trip
distance record will be cleared.
3.The computer automatically starts measuring the riding time
upon receipt of wheel signals. If you are riding your Bike 1,
whenever you stop, the computer will continue to count the
riding time for 4 more seconds to make sure there're no more
wheel signals. If you are riding your Bike 2, the computer will
count the riding time for 2 more seconds for the same reason.
Regarding the riding time it over counts, the computer will
automatically deduct it and show the correct riding time.
To Next Page
Loading...
