S 2 - M A N U A L
HALO HORIZON
Turning the body camera on/off:
Hold the power button for three seconds
The body camera will vibrate, and the HALO logo will appear on
the display screen for a few seconds.
When successfully powered up, the screen will change to the
default display.
The light ring on the front of the camera will change to solid
blue.
Hold the power button for three seconds.
The body camera will vibrate, the HALO logo will appear on the
display and the display will turn off.
The blue light ring on the front will also turn off
To turn the body camera on:
To power down the body camera:
Capturing footage:
To Record footage:
Single press the Record button
The light ring on the front of the body camera will start to
pulse blue.
The body camera will vibrate and a counter (time) will appear
on the screen.
To stop recording
Single press the Record button.
The light ring will stop pulsing blue.
The counter on screen will disappear.
WiFi:
The body cameras are generally pre-configured with the
customer’s SSID and password prior to shipping and will connect
automatically to the pre-configured Access point once it is in
range. You can also connect the Camera to the access point using
WPS (if enabled). If the camera is disconnected from WiFi, the
symbol below will appear.
If the body camera is connected to WiFi, it will indicate signal
strength by how many bars change from grey to white. This image
indicates that the WiFi is connected, and the signal strength is
strong.
Page 3
To Next Page
Loading...