5
6.2. Automatic Bluetooth
®
connection (after successful pairing)
Note
•Make surethat your Bluetooth
®
-capable terminal device is on and Bluetooth
®
is activated.
•Make surethat your Bluetooth
®
-capable terminal device is visible for other
Bluetooth
®
devices.
•For moreinformation, please refer to the operating instructions of your terminal
device.
•The Bluetooth
®
remote release remains connected to the Bluetooth
®
device it was
last paired with.
•Press and hold the on/off button (2) for approx. 3seconds to turn on the Bluetooth
®
remote release. The indicator light (1) begins to ash blue.
•After 3–5 seconds, the Bluetooth
®
remote release automatically connects to the
device.
•You can now use the Bluetooth
®
remote release.
Note –Connection impaired
After the devices have been paired once, the connection is then established
automatically.Ifthe Bluetooth
®
connection is not established automatically,check
the following:
•Check the Bluetooth
®
settings of your terminal device to see whether hama
Funstand57 is connected. If not, repeat the steps listed under 6.1. Bluetooth
®
pairing.
•Check whether obstacles areimpairing the range. If so, move the devices closer
together.
•The performance can also be affected by aweak battery.Change the battery
if necessary.
•Only one Bluetooth
®
device can be connected at atime. If thereisanactive
connection to another device, deactivate this connection and try again.
6.3. Replacing the batteries
The battery has been designed to last for up to 2,000 shots, although this depends
on the conditions of use.
If the
Bluetooth
®
remote release does not respond after you
press the release button (2), or does not connect to the terminal device, etc., change the
battery as follows: See (B).
To Next Page
Loading...
