2
G Operating instruction
1. ExplanationofWarning Symbols and Notes
Warning
This symbol is used to indicate safety instructions or
to draw your attention to specichazards and risks.
Note
This symbol is used to indicate additional information
or important notes.
2. Package Contents
• „Roundly“ radio-controlledalarm clock
•1AA battery
•These operating instructions
3. Safety Instructions
•The product is intended for private, non-commercial
use only.
•Protect theproduct from dirt, moistureand overheat-
ing,and only useitinadryenvironment.
•Donot use theproduct in areaswhere the useof
electronic devices is not permitted.
•Donot placethe product near interference elds,metal
frames, computers, TVs, etc. Electronic
devicesand window frames cannegatively affect the
product’sfunctionality.
•Donot drop theproductand do not exposeittoany
major shocks.
•Donot attempt to service or repair the product
yourself.Leave any and all service work to
qualied experts.
•Donot modify theproductinany way. Doing so voids
the warranty.
•Keepthe packaging materialout of the reach of
children due to theriskofsuffocation.
•Disposeofpackaging material immediatelyaccording
to locally applicable regulations.
Warning –Batteries
•When inserting batteries, note the correct polarity
(+ and -markings) and insert the batteries
accordingly.Failure to do so could result in the
batteries leaking or exploding.
•Only use batteries (or rechargeable batteries) that
match the specied type.
•Beforeyou insert the batteries, clean the battery
contacts and the polar contacts.
•Donot allow children to change batteries without
supervision.
•Donot mix old and new batteries or batteries of a
different type or make.
•Remove the batteries from products that arenot
being used for an extended period (unless these
arebeing kept ready for an emergency).
•Donot short-circuit batteries.
•Donot charge batteries.
•Donot throw batteries in a re.
•Keep batteries out of the reach of children.
•Never open, damage or swallow batteries or allow
them to enter the environment. They can contain
toxic, environmentally harmful heavy metals.
•Immediately remove and dispose of dead batteries
from the product.
•Avoid storing, charging or using batteries in
extreme temperatures.
4. Getting Started
4.1 Inserting the battery
Remove the battery that was already inserted into the
clock, remove the protective lm if necessary as well as
the contact interrupter and the re-insert the battery with
the correct polarity.The clock is ready for operation.