7
7. Bluetooth
®
pairing
Youcan pair your devices with the loudspeaker using
Bluetooth and use this as aplayback device for audio signals.
Youcan control playback directly on the terminal device. The
volume can also be controlled directly on the loudspeaker .
Note –Bluetooth
®
• Check whether your mobile device (smartphone, tablet
PC. etc.) is Bluetooth-capable.
• Note that the maximum range for Bluetooth
®
is 10
metres without obstacles such as walls, people, etc.
• The connection may be disrupted by other Bluetooth
®
devices/connections in the vicinity.
• The loudspeaker can only ever be paired with one
device at atime.
• Note that compatibility depends on the supported
Bluetooth
®
proles as well as the Bluetooth
®
versions
being used. (See: Technical data in the operating
instructions for the respective device)
• Ensureyour Bluetooth-enabled device is switched on
and that Bluetooth is activated.
• Press and hold [Bluetooth](2) for approximately
2seconds to activate pairing mode.
• The status LED starts to ash blue and asignal tone
is heard.
• Open the Bluetooth settings on your device and wait
until the Hama SIRIUM1000ABT is shown in the list
of found Bluetooth devices.
• If necessary,start searching for Bluetooth devices on
your device.
• Select the Hama SIRIUM1000ABT loudspeaker in the
list of available devices and wait until the loudspeaker is
shown as connected in your device's Bluetooth settings.
• The Bluetooth status LED now lights up solid blue.
• Start and control audio playback using the controls on
your device.
Note –Bluetooth
®
password
Some devices requireapasswordinorder to connect to
another Bluetooth
®
device.
• If your device requests apasswordtoconnect to the
loudspeaker,enter 0000.
7.1 Automatic
Bluetooth
®
connection
(after successful pairing)
• Devices that have already been paired with the loudspeaker
arestored automatically on the loudspeaker.
Note -connection impaired
After the loudspeaker and device have been paired,
aconnection is established automatically.Ifthe
Bluetooth
®
connection is not established automatically,
check the following:
• Check the
Bluetooth
®
settings of your device to see
whether SIRIUM1000ABT is connected. If not, repeat
the steps listed under
Bluetooth
®
pairing.
• Check that your device and the loudspeaker are
less than 10 metres apart. If not, move them closer
together.
• Check whether obstacles areimpairing the range.
If so, move the devices closer together.
7.2 Terminating the
Bluetooth
®
connection
• Change to adifferent mode to terminate the
Bluetooth
®
connection between the loudspeaker and the device.
• Alternatively,you can terminate the connection manually
on your device.
8. Network streaming
The loudspeaker allows audio les stored on aPC, tablet
or smartphone to be played.
Note
• Please note that, depending on the source device
you areusing, other softwarethat allows streaming
may be required.
8.1 Playback from acomputer (streaming)
Youcan manage the loudspeaker via your computer
and stream music to it from your computer.
Requirements:
• The loudspeaker and computer must be on the
same network.
• The loudspeaker must have been authorised as
aplayback device on the computer.
To Next Page
Loading...
