Behaviour of the LED indicator
Indicator LED Behaviour Description
System indicator Flashes orange
The system is starting and searching for anetwork
connection. Wait until the LEDs light up solid and the
network connection has been established.
Network
indicator
Lights up soild green
The Loudspeaker is connected to anetwork.
LED 1-3pulses red,
LED 5pulses green
WIFI is disconnected. Initial setup can be carried out via
the Hama Smart Audio App.
LED 1-3quickly ashes red,
LED 5quickly ashes green
WPS mode is active.
LED 1-3slowly ashes red,
LED 5slowly ashes green
WACMode is active.
Amazon Alexa
voice assistant
Alternating quick ashes of
blue and cyan
Alexa is processing and responding to avoice command.
No further voice commands can be given.
Lights up solid red
Mute mode is active. All microphones aremuted. Alexa
does not respond to the activation word.
Flashes red
Thereisnoconnection with the Amazon server.Alexa is
unable to accept voice commands.
Bluetooth
indicator
Pulses blue
The loudspeaker is in Bluetooth mode. Thereisno
connection with amobile device.
Flashes blue
The loudspeaker is in Bluetooth pairing mode. The rst
connection can be established with amobile device.
Lights up solid blue
The loudspeaker is in Bluetooth mode. Aconnection has
been successfully established with amobile device.
Volume indicator
Lights up white for 3s
Volume 20%
Lights up white for 3s
Volume 40%
Lights up white for 3s
Volume 60%
Lights up white for 3s
Volume 80%
Lights up white for 3s
Volume 100%
Battery charge
level indicator
Flashes red for 3s
Battery charge level <10%
Lights up red for 3s
Battery charge level 10 -30%
Lights up yellow for 3s
Battery charge level 30 -40%
Lights up yellow for 3s
Battery charge level 40 -60%
Lights up green for 3s
Battery charge level 60 -80%
Lights up green for 3s
Battery charge level 80 -100%
Update Flashes white An update is currenty in progress.
Note
• Forreasons of environmental protection and to save valuable rawmaterials, the brightness of the LED is dimmed after
15 minutes of no commands being issued. If acommand is then issued, the brightness of the LED display is restored
to its original setting.
To Next Page
Loading...
