Need help?Do you have a question about the Hameg HMP2030 and is the answer not in the manual?
General| Number of Channels | 3 |
|---|---|
| Display | LCD |
| Load Regulation | < 0.01% + 2 mV |
| Line Regulation | < 0.01% + 2 mV |
| Interface | USB |
| Temperature Coefficient | 100 ppm/°C |
| Output Voltage | 0-30V |
| Output Current | 0-3A |
| Protection | Overvoltage, Overcurrent, Overtemperature |
Details the voltage, current, and power specifications for the device channels.
Lists the maximum permissible voltage, current, and reverse voltage values.
Explains warning symbols used in the manual for safety and instrument protection.
General safety guidelines, warnings about high voltage, and proper handling.
Specifies acceptable environmental conditions for safe and reliable operation.
Instructions for changing the mains voltage and replacing the line fuse for safety.
Identifies and describes the function of each button and display element on the front panel.
Introduces the basic operation and startup procedure for the power supply.
Guides on initial setup and switching the instrument on for the first time.
Step-by-step guide on setting the desired output voltage for each channel.
Instructions on setting the maximum current output to protect loads and the instrument.
Describes how to link electronic fuses of individual channels for coordinated protection.
Explains how to link channels to adjust voltage/current simultaneously.
How to set overvoltage protection limits for each channel to safeguard loads.
Introduces generating custom voltage/current waveforms using the Arbitrary function.
SCPI commands for setting and querying voltage levels and step sizes.
SCPI commands for setting and querying current limits and step sizes.
SCPI commands for setting and querying overvoltage protection levels.
Explains how to use sense inputs to compensate for voltage drops in output cables.
Guidance on connecting channels in series for higher voltage or parallel for higher current.
To Next Page
