Temperature limiter tripped Set the hot and cold power
switches to OFF position.
Wait five minutes, then set
switches to ON position.
Wait 30 minutes for water
to heat or cool.
Water is not hot Dispenser is unplugged Push plug completely into
outlet
Heating switch not on Check to be sure heating
switch is turned to ON
The fuse is blown/circuit Replace house fuse or reset
breaker is tripped circuit breaker.
If too many items are
plugged into a single
circuit, move some items
to a different circuit
Temperature limiter tripped Set the hot and cold power
switches to OFF position.
Wait five minutes, then set
switches to ON position.
Wait 30 minutes for water
to heat or cool.
PROBLEM POSSIBLE CAUSES SOLUTION
No water running 1. empty bottle 1. replace with new bottle
out from faucets 2. inlet of bottle supporter 2. clean out wasted paper
blocked by bottle seal and bottle seal, install
bottle again
Water dispenser does 1. empty water bottle 1. replace with new bottle
not work 2. mineral deposits clogging tank 2. see Care and Cleaning.
Water dispenser leaks crack or pin hole in bottle replace with new bottle
from the outside
Compressor runs too 1. room temperature is hotter This may be necessary to
frequently than normal maintain a constant
temperature during hot
and humid days
2. dispenser does not have Check to be sure unit is
proper clearance properly located to ensure
adequate airflow
Noisy operation improper installation place the machine on level
surface
13
To Next Page
Loading...
