5
How to Assemble
Before first use: After unpacking Juice Extractor, remove cardboard
from Filter Basket and wash everything except Base in warm, soapy
water. Rinse and dry immediately. Never immerse Base in water or other
liquids; wipe it with a damp sponge.
Strainer Basket
Small ridge
inside Feed
Chute
1. Place Strainer Bowl on top
of Motor Base. Then place
Stainless Steel Strainer Basket
inside Strainer Bowl.
2. With hands on outer edge,
press Strainer Basket down
firmly to latch into position.
3. Place Juicer Cover over
Strainer Bowl, positioning Feed
Chute over Strainer Basket,
and lower into position.
4. Raise Locking Arm up to lock
into place.
5. Place Pulp Container into
position by tilting Container
slightly.
6. Place Juice Cup under Juice Spout. Slide Food Pusher down Feed
Chute by aligning groove in Food Pusher with small ridge on inside of
top of feed tube.
NOTE:
When unit is properly
assembled, the control panel will
illuminate when plugged in.
HINT:
To minimize cleanup, place
a plastic grocery bag in Pulp
Container to collect pulp. (See
page 6 for more information.)
To Next Page
Loading...
