6
How to Use
w WARNING
Laceration Hazard.
Never use fingers to push food down the feed chute or to clear the
feed chute. Always use the food pusher provided.
Wash fruits and vegetables.
NOTE: Most fruits and
vegetables such as apples,
carrots, and cucumbers will
not need to be cut since they
will fit into Feed Chute whole.
It is recommended that fruits
or vegetables such as oranges,
melons, or mangoes are
peeled before placing in unit to
minimize impact on juice flavor.
1. Ensure that unit is correctly
assembled (see page 5)
and place Juice Cup under
Spout.
2. Make sure Knob is in OFF
( ) position. Plug into outlet.
Control panel will illuminate.
Move Knob to LO or Hl.
NOTE: See Juicing Chart
and Tips on pages 8 and 9.
3. With motor running, place
food down Feed Chute.
Using Food Pusher, gently
guide food down Feed
Chute. To extract maximum
amount of juice, always
push Food Pusher down
slowly.
Juice will flow into Juice
Cup and separated pulp
will accumulate in Pulp
Container.
NOTE: Pulp Container can
be emptied during juicing
by turning Juice Extractor
OFF ( ) and then carefully
removing Pulp Container.
Replace empty Pulp
Container before continuing
to juice.
4. To minimize cleanup, place a
plastic grocery bag in Pulp
Container to collect pulp.
When juicing is completed,
simply remove grocery bag
containing pulp.
NOTE: Do not allow Pulp
Container to overfill since
this may prevent correct
operation or damage the
unit.
NOTE: When juicing large
amounts in one session, it is
recommended to occasionally
clean Strainer Basket to remove
excess fiber buildup. Refer to
Care and Cleaning on page 8.
To Next Page
Loading...
