Need help?Do you have a question about the Hamilton Car Wash and is the answer not in the manual?
Provides general information and guidance for installing the Commander pay station.
Details about the included warranty card and its submission requirements.
Emphasizes the need for a dedicated power source for the Commander unit.
Instructions for safely receiving and unpacking the Commander pay station.
Lists specific packing materials to remove for proper operation.
Guidelines for optimal placement of the Commander unit relative to the wash entrance.
Describes methods for securely mounting the Commander unit, including brick and base mounting.
Details requirements and locations for running electrical conduits for wiring.
Provides detailed diagrams and measurements for the brick-in cabinet installation.
Provides detailed diagrams and measurements for the free-standing cabinet installation.
Details dimensions and diagrams for mounting the free-standing cabinet to a curb or base.
Illustrates typical lane layouts and wiring connections for use with gates.
Details the types and quantities of wires required for Commander installation.
Provides instructions for making electrical connections for the CVT and power supply.
Presents diagrams illustrating utility box connections for the Commander unit.
Explains how to configure cycle synchronization settings (Passive vs. Active).
Shows schematics for connecting the power supply and controller components.
Illustrates the connections and layout of the distribution board for the Commander unit.
Outlines the terms and conditions of the limited warranty for new equipment.
To Next Page
General