The negative film holder allows you to load a color or monochrome
filmstrip up to six frames.
1. Hold up the negative toward the light. As you look through the
negative, you should be able to read the small negative
numbers normally (not a mirror image). Now turn the negative
so the image is upside down while looking at the same side.
2. Open the negative holder at the marked spot on the top. With
the negative holder laid open, place the negative into holder
so the notches line up with the notches on the holder.
Note: Handle negatives with care. Any dust, scratches or finger
prints will show up on your saved images. If possible, use cotton
gloves when handing negatives. It is recommended to use
compressed air to remove any dust on the negatives.