65
MAINTENANCE
Tires
Operating your vehicle with worn tires will increase the possibility of skidding,
loss of control and an accident, which could result in serious injury or death.
Always replace tires when the tread depth measures 1/8” (3 mm) or less.
Improper tire inflation or the use of non-standard size or type of tires may
adversely affect vehicle handling, which could result in vehicle damage or
personal injury. Always maintain proper tire pressure. Always use
HAMMERHEAD-approved size and type of tires for this vehicle when replacing
tires.
Tire Tread Depth
Always replace tires
when tread depth is worn
to 1/8” (3 mm) or less.
Front Wheel Hub
Tightening
Front wheel bearing tightness and spindle nut retention are critical
component operations. All service must be performed by your
authorized HAMMERHEAD dealer or other qualified service facility.
Front Wheel Replacement
1. Position the vehicle on a
level surface.
2. Place the transmission in
neutral. Set the parking
brake. Stop the engine.
3. Loosen the wheel nuts
slightly.
4. Elevate the side of the
vehicle by placing a suitable
stand under the frame.
5. Remove the wheel nuts.
6. Remove the wheel.
7. Reverse steps to install.
To Next Page
Loading...
