EasyManuals Logo

Hammond SK1 Introduction

Hammond SK1
10 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
Introduction
1
INTRODUCTION
Ë Basic Hook-Up
All connections are found on the Accessory Panel on the back of the Sk-series keyboard.
A.C. Power
Your Hammond Sk-series keyboard is shipped from the factory set for 120 V.A.C. power. To connect the Sk-series
keyboard to A.C. power:
a. Locate the A.C. Power Cord and A.C. Power Adapter that came with your Sk-series keyboard.
b. Plug the A.C. Power Cord into the Adapter
c. Plug the female end of the Adapter into the receptacle on the Sk-series keyboard marked, “AC IN.”
d. Plug the 3-pronged Power Cord into an A.C. power outlet.
Audio Connections
You can either:
1. Connect the Sk-series keyboard to an amplifier, or;
2. Connect the Sk-series keyboard to a Leslie Speaker cabinet.
Connecting to an Amplifier
4
1. Use two audio cables with / " plugs on both ends of each cable.
1
2. Connect one end of each of the audio cables to the audio output connectors (marked LINE OUT) on the
Accessory Panel.
4
3. Connect the other ends of each cable to the female / " audio input connectors of your amplifier.
1
4
If your amplifier has only a single (1) female / " phono plug audio input, you can connect one end of one
1
4
cable to the L/MONO audio output connector on the Sk-series keyboard, and the other end to the female / "
1
audio input connector of your amplifier.
NOTE: If you wish to use the L/MONO output only, you should set the Audio Mode of your instrument to
MONO. This is covered in the SPECIAL UTILITY FEATURES section.
Connecting a Leslie Speaker
The 8-pin Leslie DIN socket on your Sk-series keyboard allows you to plug directly into any Leslie speaker having an 8-pin
DIN interface. If you wish to use a Leslie Speaker with your Sk-series keyboard, the Leslie Speaker should be connected
before turning the power "ON." To do this:
1. Locate the 8-pin Leslie Connector Cable.
2. Plug one end of the Connector Cable into the receptacle on the Leslie Speaker.
3. Plug the other end of the Connector Cable into the 8-pin Leslie socket found on the Accessory Panel of the
Sk-series keyboard.
Both the Leslie connections are "keyed,” that is, each connection contains a notch which insures that the pins
properly match up.

Other manuals for Hammond SK1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hammond SK1 and is the answer not in the manual?

Hammond SK1 Specifications

General IconGeneral
TypePortable Keyboard
Extra Voice SectionElectric Piano, Clavinet
EffectsReverb, Chorus, Overdrive
Leslie SimulationYes
ConnectionsMIDI In/Out, USB
Power SupplyAC adapter (included)
Manuals61 keys

Related product manuals