Your fixture is made from quality materials that will last many years with minimum care. You may want to
periodically clean the diffuser, or interior of fixture using a mild, non-abrasive glass cleaner and a soft cloth.
DO NOT use solvents, or cleaners containing abrasive agents. When cleaning the inside of the fixture, make sure
you have the power turned off, and do not spray liquid cleaner directly onto the LEDs, LED driver or wiring.
Problem Possible Cause Corrective Action
The power is off. Check if power supply is on.
The fixture does not light. There is a bad wire connection. Check the wiring.
The switch is defective. Test or replace the switch.
The fuse blows or circuit breaker The wires are crossed or the power wire Check the wiring connections.
trips when the light is turned on. is grounded out.
Minor problems often can be fixed without the help of an electrician.
Mounting the difusser to the
housing plate
■
Position the diffuser (B) so that it
becomes seated in the housing plate
(A). Turn the diffuser (B) clockwise to
secure it.
■
Restore power to the electrical box.
Turn the light switch on to activate the
fixture.
5
6
Installation (continued)
Troubleshooting
Care & Cleaning
CAUTION: Before attempting to clean the fixture,
disconnect the power to the fixture by turning the breaker
off or removing the fuse from the fuse box.
WARNING: Before doing any work on the fixture,
shut off power supply at the circuit panel to avoid
electrical shock.
A
B
To Next Page
Loading...