HAMPTON BAY BenjiLock

To Next Page

Your BenjiLock By Hampton™ arrives partially charged.

To ensure the best experience, we recommend that you charge your BenjiLock By

Hampton™ fully before you begin programming.

Charge your BenjiLock By Hampton™

1. Remove included USB cable from package.

2. Connect the USB cable to the lock (bottom) and to a standard USB input.

3. Note the RED LED on the top of your lock.

4. RED LED will turn off when the unit is fully charged.

Note: A fully depleted battery will take roughly 3 hours to charge.

Program your BenjiLock By Hampton™ (Master User)

Programming note: The first user added will be the owner of the lock and will be needed

to add/remove additional users.

1. Wake up the lock: Touch the fingerprint sensor and BLUE LEDS will illuminate

around the fingerprint sensor.

2. Insert the key and turn counterclockwise until the BLUE LED fingerprint sensor

light appears solid.

3. Press any finger against touch screen until BLUE LED fingerprint sensor light

flashes.

4. Press the silver button at the bottom of the lock one time.

5. Wait two seconds until the LED light flashes BLUE at the top of the lock.

6. The LED at the top of the lock will flash once for user 1.

7. Place your finger on the fingerprint sensor until the BLUE LED at the top of the

lock turns on and remove your finger after it turns off.

8. Repeat the previous step four more times with the same finger for a total of 5

times. On the fifth time, remove your finger once the BLUE LED light appears

solid. The light will then blink multiple times indicating successful programming.

9. Remove the key, and your lock is programmed for one of its users.

Troubleshooting: If the LED at the top of the lock flashes RED, this means your

fingerprint has not been recorded. If this happens, simply continue following the steps

for programming.

Add additional users to your BenjiLock By Hampton™

1. Wake up the lock: Touch the fingerprint sensor with a finger that is not

programmed and the BLUE LED fingerprint sensor light will flash.

2. Insert the key and turn counterclockwise until the BLUE LED fingerprint sensor

light appears solid.

3. Authenticate permission to add users by placing the first finger programmed

(Master User) on the fingerprint sensor until the LED light on top of the lock

turns blue.

4. You now press the silver button at the bottom of the lock 2-10 times to

correspond to the user you are programming.

Note: Pressing the silver button 2 times corresponds to user 2, 3 times

corresponds to user 3, etc.

Need help?

Do you have a question about the HAMPTON BAY BenjiLock and is the answer not in the manual?

Summary

BenjiLock By Hampton Operation Guide

Charge Your BenjiLock

Instructions for charging the BenjiLock using the included USB cable until the RED LED turns off.

Program Master User

Steps to program the first fingerprint as the lock's owner, enabling further user management.

Troubleshooting Programming

Guidance for when the lock's LED flashes RED, indicating a failed fingerprint recording.

BenjiLock By Hampton User Management

Add Additional Users

Procedures to add more authorized users after the Master User is set up, with step-by-step instructions.

Delete Specific User

Steps to erase a specific user's fingerprint from the lock by entering the user number.

Master Reset (Delete All Users)

Instructions to reset the lock to factory defaults, removing all programmed users and settings.