Need help?Do you have a question about the Hand Held Products 3800 and is the answer not in the manual?
General| Brand | Hand Held Products |
|---|---|
| Model | 3800 |
| Category | Barcode Reader |
| Language | English |
Guide for connecting the scanner via keyboard wedge interface to terminal/PC.
Configuration for IBM 4683 terminal interfaces using Plug and Play codes.
Instructions for configuring the scanner using USB interfaces.
Steps to establish a keyboard wedge connection to an IBM PC AT.
How to set the Terminal ID for scanner configuration based on supported terminals.
Steps for connecting the scanner via a serial port using RS-232 protocol.
Configuration of data transmission speed (baud rate) for serial communication.
Settings for data bits, stop bits, and parity in RS-232 communication.
Configuration of handshake protocols for RS-232 serial communication.
Adjusts scanner performance and current draw by changing scan speed.
Configures how the scanner is activated for scanning (Manual/Serial, Automatic, Low Power).
Explains adding data before/after scanned barcodes to form message strings.
Step-by-step guide to adding prefixes or suffixes to symbologies.
Procedures for removing single or all prefixes/suffixes for symbologies.
Adds a carriage return suffix to all barcode symbologies at once.
Overview of editing scanned data formats using the Data Format Editor.
Step-by-step guide to creating new data formats for the scanner.
Configuring Code 39 wand emulation for the secondary interface.
Setting up the secondary interface via RS-232 communication.
Configuring non-decoded laser emulation for the secondary interface.
Enables or disables all supported barcode symbologies.
Configuration settings for Codabar symbology.
Configuration settings for Code 39 symbology.
Configuration settings for Interleaved 2 of 5 symbology.
Configuration settings for Code 93 symbology.
Configuration settings for Code 2 of 5 symbology.
Configuration settings for IATA Code 2 of 5 symbology.
Configuration settings for Matrix 2 of 5 symbology.
Configuration settings for Code 11 symbology.
Configuration settings for Code 128 symbology.
Configuration settings for Telepen symbology.
Configuration settings for UPC A symbology.
Configuration settings for UPC E symbology.
Configuration settings for EAN/JAN 13 symbology.
Configuration settings for EAN/JAN 8 symbology.
Configuration settings for MSI symbology.
Configuration settings for Plessey symbology.
Step-by-step guide to cloning scanner settings from a source to a destination scanner.
Restores the scanner to its original factory default settings.
Guide to diagnose and resolve scanner operational issues.
Details the warranty terms and conditions, exclusions, and limitations of liability.
To Next Page
