HandHeld ALGIZ RT10 - Ethernet Connection and IP Settings

Version1.0 

5.1.5 Ethernet
ToconnecttoanEthernetnetwork,usethe"Ethernet"optionunderWireless&networkssettings.
The"EnableEthernet"optionshowninFIGURE5.12.ETHERNETOPTIONSallowsyoutoturnONor
turnOFFtheEthernetconnectionasneeded.

ToEnableEthernetyouhavetoReboottheTablet.
Figure5.12EthernetOptions
FIGURE5.13,“ETHERNETIPAssignmentsSettings
The"EthernetIPAssignment"optionprovidestwomethodsofconfiguringtheEthernetport:
 AutomaticIPaddressconfigurationusingDHCP.Thisisonbydefault
 StaticIPaddress
Youmaydirectlyassigntheproperties oftheEthernetportusing"StaticIP"option.Todo
this,youneedstohavethefollowinginformationhandy:
 TheIPaddressyouwishtoassigntothedevice
 Thenetmaskofthenetworkyouareconnectingto
 TheIPaddressofthegateway
 TheIPaddressoftheDNSserver
AlltheIPaddresses(interfaceaddress,gateway,DNS)areenteredindottedIPnotation e.g.
"192.168.100.152".ThenetmaskneedstobeenteredinCIDRformat,e.g."20"isequivalent
to"255.255.255.0".
ToconfigurethestaticIP:
 Change"EthernetIPAssignment"optionto"StaticIP".
 Select"StaticIPSettings" assh own inFIGURE5.13,“ETHERNE TIPAssignmentsSettings”
 EnterthevaluesinStaticIPconfigurationdialogasshown FIGURE5. 14 . ST A TI C IP
CONFIGURAT ION DIALOG

YoucanseetheinformationabouttheEthernetportbyselecting"properties"optioninmenu
atthetop‐rightcorner.Adialogpopsupwithinformation.ThisdialogshowstheMACaddress
oftheEthernetport,asshowninFigure5.20,“EthernetProperties”.
FIGURE5.14.STATICIPCONFIGURATIONDIALOG





FIGURE5.15.ETHERNETPROPERTIES
 