HandiSOLUTIONS HandiWALL User Manual

Figure 1. Level HandiWALL® before attaching it to the wall
Figure 2. HandiWALL® installation.
NOTE: Observe all safety precautions
and wear all safety equipment before
proceeding!
1. If necessary, cut your Handi-
WALL® panels to the desired
length using an electric saw with
a thin sharp blade.
2. Mark on your wall where you
want the bottom of your Hand-
iWall® installation to begin (this
may be your oor). (See Figure 1)
3. Locate your studs and fasten the
bottom panel of HandiWALL®
with the provided screws. Be
sure to make sure the panel is
level before installing screws.
(See Figure 2)
4. Proceed to install the next Hand-
iWALL® panel on top the rst
leveled panel. HandiWALL® can
be cut horizontally if necessary.
Continue with all panels until
complete. Install nish trim.
Installation on Concrete on other side
HandiWALL® Installation on Drywall
GarageCabinets.com
GarageCabinets.com

HandiSOLUTIONS HandiWALL Specifications

General

Brand	HandiSOLUTIONS
Model	HandiWALL
Category	Tools
Language	English

Summary

HandiWALL® Installation on Drywall

Panel Preparation and Marking

Cut HandiWALL® panels to desired length and mark the starting point on the wall.

Fastening the Bottom Panel

Locate studs and fasten the bottom panel, ensuring it is level before installing screws.

Completing Wall Installation

Install subsequent panels, cut horizontally if needed, and finish with trim.

HandiWALL® Installation on Concrete

Panel Preparation and Marking

Cut HandiWALL® panels to desired length and mark the starting point on the wall.

Fastening the Bottom Panel to Concrete

Pre-drill concrete and fasten the first leveled panel using Tapcon® screws.

Completing Wall Installation

Install subsequent panels, cut horizontally if needed, and finish with trim.