2 / 2
Opening the safe
The safe is now closed and programmed with a code.
To open the safe, key in 1 2 3 4 5 in succession, immediately followed by an "A" or "B".
As you enter the numbers, the yellow light will light on the keyboard.
Aer pressing the leer "A" or "B", the green light will light on the keyboard.
Aer this you have 5 seconds to turn the buon to the right and open the door. If a wrong code is
entered 3 mes in a row, the system will freeze for 20 seconds.
Programming your personal code
This safe works with a personal code from 3 to 8 digits followed by an "A" or "B".
This code is not pre -programmed and you can choose one yourself.
Choose a new code from 3 to 8 digits and write them immediately down on paper, so you don't forget
how you can open your safe.
1) Open the safe (see above).
2) Press the red buon (a), on the back of the door and a yellow light will light on to indicate that
the old code has been erased and the system is ready to receive your personal code.
3) Enter your personal code and then press "A" or "B".
4) Saving the code is conrmed by 2 beeps. If the code is invalid, the yellow light will burn and 3
beeps can be heard. In this case you must enter a new code.
5) If you have tested a good combinaon, check this with the door a few mes. If opening the
safe is awless, you can close the safe.
Emergency
If you can no longer open the safe, contact the rental company. For emergencies they have access to
a key to open the safe.
To Previous Page
Loading...
General