Hanna Instruments HI5221 - 2) Direct Reading Mode and Manual Log; 3) Direct;AutoHold Reading Mode and Automatic Log; 4) Direct;AutoHold Reading Mode and Manual Log

65
2) Direct Reading Mode and Manual Log:
Real time continuous measurements are on display and
snapshots of measurement data are stored in the Manual
log when the user presses
. Subsequent snapshots
will be added to the same Manual Lot every time the
is depressed unless New Lot is selected under
Log options.
Note: When the
is pressed the lot ID along
with the current record number will appear for
short time on the selected channel window on the
top/left corner (e.g. L033_MV 8 - this means lot
ID L033_mV and record number 8).
3) Direct/AutoHold Reading Mode and Automatic Log
Press
and then keys must be pressed
on front display to initiate this function. Real time continuous
measurements are on display with “AutoHold” flashing
and real time continuous logging into meter memory,
until the meter reaches the stability criteria to go into
AutoHold mode. The stored sample logs will be marked
with an “H” to indicate the AutoHold mode. The virtual
key returns operation to real time continuous
measurements and stops the logging session.
4) Direct/AutoHold Reading Mode and Manual Log
Press
in order to add one new record in the log report. The manual log is working even
if it is in AutoHold or Continuous Reading mode. Press to initiate the AutoHold event.
“AutoHold” will flash until the stability criteria is reached and then the screen freezes in Auto
Hold mode, the data is marked with an “H”.
LOGGING