User’s Manual
ERROR MESSAGE & POSSIBLE SOLUTIONS
CABLE NOT CONNECTED:
1. Check that the signal-cable is properly connected, if the connector is loose; tighten the
connector’s screws.
2. Check the signal-cable’s connection pins for damage.
INPUT NOT SUPPORT :
Your computer has been set to unsuitable display mode, set the computer to display mode given
in the following table.
FACTORY PRESET TIMING TABLE:
MODE
RESOLUTION
HORIZONTAL
FREQUENCY (KHz)
VERTICAL
FREQUENCY (Hz)
1 640x350@70Hz 31.469 70.087
2 640x400@70Hz 31.469 70.087
3 720x400@70Hz 31.469 70.087
4 640x480@60Hz 31.469 59.94
5 640x480@67Hz 35 66.667
6 640x480@72Hz 37.861 72.809
7 640x480@75Hz 37.5 75
8 800x600@56Hz 35.156 56.25
9 800x600@60Hz 37.879 60.317
10 800x600@72Hz 48.077 72.188
11 800x600@75Hz 46.875 75
12 832x624@74.6Hz 49.725 74.5
13 1024x768@60Hz 48.363 60.004
14 1024x768@70Hz 56.476 70.069
15 1024x768@75Hz 60.023 75.029
16 1152x864@75Hz 67.5 75
17 1152x870@75Hz 68.681 75.062
18 1280x720@60Hz 45 60
19 1280x768@60Hz 47.396 59.995
20 1280x768@75Hz 60.289 74.893
21 1280x960@60Hz 60 60
22 1280x960@75Hz 74.592 74.443
23 1280x1024@60Hz 63.981 60.02
24 1280x1024@75Hz 79.976 75.025
25 1360x768@60Hz 47.712 60.015
26 1440x900@60Hz 55.935 59.887
27 1440x900@75Hz 70.635 74.984
19
To Next Page
Loading...
