4. Use a soft brush to clean all the parts, and then use clean water to flush them.
5. After cleaning, fix the parts on opposite sides.
Ice maker water inlet box cleaning
Fig. A Fig. B
Fig. C
① Cover board of ice make machine ② Perch
③ Baffle plate of water inlet box ④ Water inlet box of ice make machine
1) Move up and rotate the cover board of ice maker machine ① to certain angle, then push backwards to
separate the cover board from the perch ② so that it can be easily taken out.（Fig.A）
2) Twist off the two screw of the perch ② to take the perch out. （Fig.B）
3) Insert a flathead screwdriver into the gap between baffle plate of water inlet box ③ and ice maker water
inlet box. Pry it off following the arrow direction and make the buckle separately then take out the
baffle plate ③. （Fig.C, Fig.D）
4) Use a brush to clean the ice maker water inlet box ④（Fig.D）
5) Re-install all the parts after clean up
To Next Page
Loading...
