Hanover DG3 - 3.3.2 Route code; 3.3.3 Information code

DG3 Controller – Installation and Operation
Manual
540846-3 page 24 of 64 25/09/2015
4
Press the up arrow key
5
Press the left arrow key
6
Press the up arrow key
7
Press the up arrow key
8
Press the up arrow key
9
Press the up arrow key
10
Press F/E key to select your new destination number and
the destination Brownford will appear as shown
Route code
The route code is accessible if the configuration codes RN and RB are set to enable (refer to Appendix E:
Configuration Code Options). Where several destinations for a particular route are managed together, the
'Route Browse' function can be used (see section 7 of the Helen v3.3 display-editing software - operating
manual (ref. 540125)). The route code (ideally the same number as the route number - but not necessarily)
is then used to group these destinations together. Route code is also used for entering a route number
with a destination. It is shown as Route no:.
Information code
The information code, accessible if the configuration code IN is set to enable (refer to Appendix E:
Configuration Code Options), refers to a general passenger information message which is periodically
73A BROWNFORD
32 19  0014
Route no: _
43
Dest no: 1
0 0 2 3
Dest no: 10
0 0 2 3
Dest no: 13
0 0 2 3
Dest no: 12
0 0 2 3
Dest no: 11
0 0 2 3
Dest no: 14
0 0 2 3