DG3 Controller – Installation and Operation
Manual
540846-3 page 58 of 64 25/09/2015
Appendix D: Sign Options
This appendix lists all functions available in the sign options and their values selected by using the F/E
key:
S1 - Sign 1
S2 - Sign 2
S3 - Sign 3
S4 - Sign 4
S5 - Sign 5
S6 - Sign 6
S7 - Sign 7
S8 - Sign 8
S9 - Sign 9
SA - Sign 10
SB - Sign 11
SC - Sign 12
SD - Sign 13
SE - Sign 14
LN - Internal
Sign Number
Automatic assignment, i.e the switch number setting in the sign is
the same as that in the controller’s database, as determined by
Helen software
The number of the sign assigned by Helen software
Hanvox voice announcement system
Hancis (or HTC) on-board computer
This parameter should only be used if your DG3 has a Hancis or
HTC unit connected to the physical sign system in your vehicle.
Setting sign no. to the ‘Hancis/HTC’ value will enable the DG3 to
remotely control certain features of the Hancis/HTC unit. It will also
add an additional Hancis/HTC menu item under the main function
menu.
To use this feature, you have to configure a sign to be “RN”. If any
signs are configured as RN, then the ‘R’ key will be available to
accept a manually entered alphanumeric value which will be sent
directly to only those signs configured as RN.
When switched on, this option allows faster delivery of information to
the sign and is thus used to speed up delivery of large-sized graphic
messages.
Note: It has no effect on Super-X messages, whether or not they
contain graphic images.
To Next Page
Loading...