Why is temperature regulation not possible with my Hans Grohe Pharo DP Lift 2 M 20?
If you can only get hot or cold water with your Hans Grohe Plumbing Product, the thermostatic cartridge might be defective and needs to be exchanged. Alternatively, if this is a new installation, the connection hoses might be exchanged; ensure they are installed correctly.
What to do if Hans Grohe Plumbing Product shower is dripping?
If your Hans Grohe Plumbing Product shower is dripping, the cartridge of the Quattrostat may be defective. In this case, exchange the cartridge.
How to fix low water level in Hans Grohe Plumbing Product handshower?
If the water level is too low and your Hans Grohe Plumbing Product handshower is delivering insufficient water, it could be due to a dirty filter in the angled hose connection or the filter of the handshower itself. Clean the filter in either or both locations.
Why is the cartridge of Quattrostat stiff in my Hans Grohe Pharo DP Lift 2 M 20?
If the cartridge of your Hans Grohe Plumbing Product Quattrostat is stiff, the nut of the cartridge might be screwed too tight. First, screw the nut tight, then loosen it approximately 12°.
General| Brand | Hansgrohe |
|---|---|
| Series | Pharo |
| Installation Type | Wall Mounted |
| Thermostatic | Yes |
| Hand Shower Included | Yes |
| Model | DP Lift 2 M 20 |
| Flow Rate | 2.5 GPM |
| Water Pressure | 2 bar |
| Hand Shower Hose Length | 1.5 m |
Lists parts included for the main shower panel assembly.
Lists parts specifically for the corner installation configuration.
Details the necessary tools for performing the installation.
Diagram showing precise measurements for mounting the panel on a wall.
Diagram showing precise measurements for mounting the panel in a corner.
Diagram identifying all functional parts of the shower panel unit.
Table detailing flow rates, operating pressures, and temperatures.
To Next Page