Operating Data Logger
USER’S MANUAL 23
measure points will be displayed on the screen.
6) Click “A” to return to 600mA measurement.
Connect Data Logger probes (HT325) with DMM-365 as illustrated in the following figure:
Figure 2-11
Then, the following figure will be displayed on the screen:
Figure 2-12 AC current Measurement for 10A
2.3 Measuring Resistance Values
To measure a resistance, follow these steps:
1) Click the “OHM” key and then resistance measurement window appears on the screen.
2) Connect the black lead into the COM banana jack input and the red lead into the V/Ω/C banana
jack input.
3) Connect the red and black test leads to the resistor. The resistance value is shown on the
screen in Ohm.
To Next Page
Loading...