Using a 5mm Allen wrench and a 10mm open end
wrench, remove the (2) bolts attaching the turn signal
to the OEM tail rack and let the turn signal hang out of
the way. See Fig 1.
Repeat for other turn signal.
Using a 5mm Allen wrench, remove the (2) bolts near
the center of the tail plate. See Fig 2.
Remove the OEM Tail Plate, unattach the turn signal
wiring from the bottom of the tail plate, and set the
turn signals out of the way. See Fig 3.
Fig1
Fig 2
Fig 3
Step 1
Step 2
Step 3
HTP4-8-7 KLR 650 ELITE TAIL PLATE SYSTEM
ank you for purchasing Happy Trails products. Our products are proudly hand made in Boise
Idaho, USA. If you have any questions or concerns about the installation of this product, please con-
tact us directly at 1-800-444-8770 or e-mail installation@happy-trail.com.
Before you begin, place the bike on a hard level surface where you have room to work. Lay out the
parts included in this kit and compare to the parts list on the nal pages of these instructions. If any
parts or hardware are missing, contact us immediately at the number or email listed above.
To Next Page
Need help?
General
