Hapton Bay MARLOWE - User Manual

Questions and Answers

T
Trevor MartinezJul 28, 2025
What to do if my Hampton Bay Fan will not start?
- D
  Dennis JonesJul 28, 2025
  If your Hampton Bay fan isn't starting, here are a few things to check: * Make sure the main and branch circuit fuses or breakers are in working order. * Verify the line wire connections to the fan and switch wire connections in the switch housing. * Check the battery in the remote control. * Ensure you are within the normal operating range of 10-20 feet for the remote. * Turn the power off and confirm that the dip switch settings are identical on both the remote control and the receiver.
G
Gina FitzpatrickAug 6, 2025
Why is my Hampton Bay Fan so noisy?
- P
  perezreginaAug 6, 2025
  A noisy Hampton Bay fan can be disruptive. Here's what to check: 1. Ensure all motor housing screws are snug. 2. Verify the screws attaching the fan blade bracket to the motor hub are tight. 3. Make sure wire nut connections aren't rattling against each other or the inside of the switch housing. 4. Allow for a 24-hour 'breaking in' period, as most new fan noises disappear during this time. 5. If using a light kit, tighten the screws securing the glassware and ensure the light bulbs are secure. 6. Confirm the canopy has a small gap and isn't touching the ceiling. 7. Check that your outlet box is secure and rubber isolator pads were used between the mounting plate and outlet box.
P
Peter MccormickAug 16, 2025
How to fix a wobbling Hampton Bay Fan?
- B
  bpriceAug 16, 2025
  If your Hampton Bay fan is wobbling, try these steps: * Ensure all blade and blade arm screws are securely tightened. * Check that blade levels are equal. Measure from a point on the ceiling above the tip of each blade to a point on the center of the blade. Any deviation should be within 1/8 inch. * Let the fan run for ten minutes. If wobbling persists, contact Customer Service for a free balancing kit.