Harbor Breeze KUJCE9603 User Manual

CEILING FAN REMOTE CONTROLLER
OPERATION AND INSTALLATION INSTRUCTIONS
(Please keep this instruction pamphlet.)
IMPORTANT POINTS TO REMEMBER:
1.Read and save these instructions.
2.Please note that all fixed wiring appliances should be installed by a qualified electrician.
3.The supply to the remote control receiver should be connected through a mains switch, i.e. existing wall
switch.
4.Disconnect from power supply at wall switch before working on remote control receiver or ceiling fan.
5.Install receiver into the ceiling fan canopy of the fan to ensure proper protection.
6.This unit is to be used for the control of ceiling fan and in a AC110/120V 60Hz power supply only.
7.Do not install in damp locations or immerse in water. (For indoor use only.)
8.Do not pull on or cut leads shorter.
9.Do not drop or bump the unit.
10. PLEASE NOTE: The battery will weaken with age and should be replaced before leaking takes place
as this will damage the transmitter. Dispose of used battery properly, keep the battery out of reach of
children.
11. CAUTION: To reduce the risk of fire or injury, do not use this product in conjunction with any variable
(rheostat) wall control.
INSTALLATION INSTRUCTIONS
1.Ceiling fan must be set at HIGH speed and light kit (If any) at ON position by pressing the “Light Switch”
after installation.
2.Once the connection has been made, the receiver inserts into the drop rod hanging bracket. The canopy
comes up to cover the receiver and bracket.
IMPORTANT
YOU MUST SET CEILING FAN MANUAL SWITCH TO HIGH SPEED AND LIGHT KIT
(IF ANY) TO ON POSITION BEFORE OPERATING REMOTE CONTROL.
CAUTION: INCORRECT WIRE CONNECTION WOULD DAMAGE THIS RECEIVER.

Harbor Breeze KUJCE9603 Specifications

General

Compatible Devices	Harbor Breeze Ceiling Fans
Battery Type	AAA
Number of Batteries	2
Type	Remote Control
Functions	Fan speed control, Light on/off/dimming
Control Method	RF (Radio Frequency)
Power Source	Battery

Summary

Important Operating Precautions

Initial Setup for Remote Operation

Set ceiling fan manual switch to high speed and light kit (if any) to ON before operating remote control.

Important Safety and Usage Guidelines

General Recommendations

Read and save instructions. Professional installation is recommended for fixed wiring appliances.

Power and Installation Safety

Disconnect power before work, install receiver in canopy, and use on specified voltage/environment.

Handling and Battery Precautions

Handle unit with care, avoid dropping, and replace batteries promptly to prevent damage and ensure safety.

Operational Restrictions

Do not use with variable wall controls. Unit is for indoor use only.

Installation Steps

Pre-operation Setup

Ensure fan is set to high speed and light (if any) is ON before final setup.

Receiver and Canopy Placement

Insert the receiver into the drop rod hanging bracket and secure with the canopy.

Code Switch Configuration

Setting Unique Codes

Set dip switches on transmitter and receiver to the same code for operation; different codes allow independent control of multiple fans.

Readiness for Use

The remote control is ready for use after battery installation.

Transmitter Functions

Fan Speed Control

Control fan speed with OFF, HI, MED, and LOW buttons.

Light Control

Turn light ON/OFF or dim/brighten with the LIGHT button (for tungsten bulbs).

Wiring Connections

Receiver Wiring Diagram

Diagram showing connections for AC power input, antenna, and fan/light outputs.

Transmitter Wall Mount

Instructions for mounting the transmitter wall holder with two screws.

FCC Compliance Information

Interference Statement

Equipment tested for Class B digital device limits; ensures reasonable protection against harmful interference.

User Encouragement for Interference Correction

User is encouraged to correct interference by reorienting antenna or adjusting separation.

FCC ID and Compliance Conditions

FCC ID: KUJCE9603. Device complies with Part 15, subject to no harmful interference and accepting received interference.