SKU 41293 For technical questions, please call 1-800-444-3353. Page 3
Assembly of the Windmill (continued)
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS
MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR
MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS
QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO
REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR
EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN
BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES
ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR
REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACE-
MENT PARTS THERETO.
10. Before placing the Wheel (#1) on the axle of the Shaft (#2A), place one Flat Washer on
the axle. When placing the Wheel (#1) on the axle, the side of the Wheel with the zerk
fitting should be facing inward towards the Shaft. With the Wheel on the axle, add the
other Flat Washer and secure in place with a Cotter Pin.
11. Attach the Wheel assembly to the Mast Head (#3) by placing the shaft portion of the
Shaft (#2A) down into the hole portion of the Mast Head (#3). Lock in place by adding a
Cotter Pin through the hole in the bottom portion of the shaft.
12. Position the Windmill in the desired flat, level location. Place the four Ground Stakes
(#9) through the oval shaped holes in the bottom of each Lower Leg Section (#5C). The
Ground Stakes should be positioned at a 45 degree angle and hammered into the soil to
secure the Windmill. Note: for a more secure mounting, a cement base is recom-
mended.
13. Greasing the Wheel (#1): Use a regular bearing grease to lubricate the Wheel several
times per year.
REV 04/05
Brought to You by Augusta Flint
To Next Page
Loading...