Item 41293 Windmill
Assembly and Operating Instructions
3491 Mission Oaks Blvd., Camarillo, CA 93011
Copyright
©
2003 by Harbor Freight Tools
®
. All rights reserved. No portion of this manual or any
artwork contained herein may be reproduced in any shape or form without the express written
consent of Harbor Freight Tools.
For technical questions and replacement parts, please call 1-800-444-3353.
Thank you for choosing a Harbor Freight Tools product. For future reference, please complete the
owner’s record below:
Model:____________________ Purchase Date:______________________
Save the receipt, warranty and these instructions. It is important that you read this entire instruc-
tion sheet to become familiar with the unit before you begin using it.
Specifications
Height: 97-1/2” Base Dimensions: 26-3/4” Square
Wheel Diameter: 22-3/4” Length of Ground Stakes: 15-1/2”
Weight: 44 Lbs.
Warning:
1. Read this instruction sheet completely before assembly or use of the Windmill.
2. Always wear ANSI approved safety goggles when working with tools and equipment.
3. Plan to locate the Windmill on a flat, level area. Installation of the Windmill should be in a
location where small children are either restricted or supervised. Never allow children to
climb on the Windmill.
4. The Windmill is for decorative purposes only. This unit is not designed for any other use.
Assembly of the Windmill:
Contents of the box is shown below with part numbers noted. Lay out all pieces on a flat working
surface. Check to make sure all parts are included and in good condition. Note: During initial
assembly, all screws and nuts should be installed only finger tight. Once the unit is fully as-
sembled, tighten down all screws and nuts.
Contents of Box Qty Contents of Box Qty Contents of Box Qty
Wheel (#1) 1 Upper Leg Section (#5A) 4 Ground Stakes (#9) 4
Shaft (#2A) 1 Middle Leg Section (#5B) 4 Hardware Package * 1 Bag
Rudder Extension (#2B) 2 Lower Leg Section (#5C) 4 *Includes:
Rudder (#2C) 1 Diagonal Brace (#6) 16 2 Flat Washers - 1/2”
Mast Head (#3) 1 Upper Brace (#7) 4 2 Cotter Pins
Platform (#4) 1 Lower Brace (#8) 4 42 Screws 3/16” - 24 x 5/8”
42 Nuts 3/16” - 24
Brought to You by Augusta Flint
To Next Page
Need help?
General