Page 8 For technical questions, please call 1-888-866-5797. Item 56416
SAFETY OPERATION MAINTENANCESETUP
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO PREVENT SERIOUS INJURY FROM FLYING DEBRIS:
Wear long pants, long sleeves and protective footwear. Wear ANSI-approved
safety goggles, dust mask, hearing protectors, and gloves.
Charging Battery Pack
Charge Battery Pack according to the instructions included with the
20 V Bauer Battery Charger (both sold separately).
Operation
TO AVOID SERIOUS INJURY AND PROPERTY DAMAGE:
Inspect the area before using the Blower. Remove all hard objects from work area.
Do not blow debris in the direction of people, animals or property.
Use both hands when operating Blower.
1. Assemble Blower according to
Assembly Instructions on page 7.
CAUTION! The Blower Tube helps prevent contact
with internal moving parts. To prevent injury, do
not use the Blower without the Tube attached.
Note: Rake or sweep to loosen debris if necessary.
2. Make sure that the Trigger is in the off-position,
then slide the Battery Pack into slot on bottom
of Blower Handle until it clicks into place.
3. Hold Blower with both hands, with the
Tube several inches off the ground.
4. Adjust Speed Control Switch to desired
setting, then press and hold Trigger.
5. To lock Blower on for continuous operation,
press Trigger fully and hold, then press and
hold the Trigger Lock. Release the Trigger
first and then the Trigger Lock. To release the
lock-on function, press the Trigger again.
6. Sweep from side to side.
7. Release Trigger when done.
Trigger
Trigger
Lock
Speed Control
Switch
8. When finished, to prevent accidents:
• Remove battery pack.
• Wipe external surfaces of the appliance
with clean cloth. Store in a dry, indoor
area out of reach of children.
To Next Page
Loading...