EasyManua.ls Logo

HARDI-EVRARD ALPHA PLUS 4100 - Optimizing Air Assistance; Air Speed Adjustment Routine

Default Icon
99 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ALPHA PLUS HARDI NOVA
DD EE SS CC RR II PP TT II OO NN AA NN DD OO PP EE RR AA TT II OO NN
CHAPTER
22-
21
Find the range of air speeds that can control drift :
Start with the air setting at zero and keep increasing the air speed just to the point where you can see
that the drift cloud is minimised - note minimum setting.
Then increase the air speed until you see drift again - note maximum setting.
Now you know the range of air speeds that can be used with minimum drift.
Spray job
Early stage row crop Low / Medium
Air assistance
Bare ground / low vegetation
Spraying only the top of a crop i.e.
Ear spraying in wheat *
Low
Penetration in open crop * Medium / High
Penetration in dense crop * High / Very high
*
Can be checked with water sensitive paper
BBaarree ggrroouunndd // llooww ccrroopp
The range of air speeds is usually very small.
TTaalllleerr ccrroopp
The taller the crop the wider the range of air speeds that can reduce drift.
AAtt hhiigghheerr wwiinndd ssppeeeeddss
More air is needed on the sprayer and it is advisable to drive more slowly and use minimum boom height
(40 cm)/(16 in).
NNOOTTEE
: Too high air speed over bare ground/low crop can cause reflection of the spray liquid and leave dust
on the leaves, which can again reduce the effect of the plant protection product.
AA
- Start with air vertical
- Set the air speed ...........
- Find the best angling .....
- Readjust the air .............
The air speed and angling must always be adjusted individually for each spray job and the given weather
conditions.
It is always a good idea to get used to a new sprayer out in a field using only water in the tank. On this occa-
sion the following routine for air adjustment should be practised :
BB
AA
IIMMPPOORRTTAANNTT !!
Fine turning of air speed and angling will often be necessary all through the spraying job.
It is easiest to find the best air setting to reduce drift when the sun is low and behind the bom (backlight)
These conditions make the drift more visible
AA
11-
22-
33-
SStteepp 11

Related product manuals