HARDI-EVRARD ALPHA PLUS 4100 - Engine Maintenance Procedures; Engine Coolant and Heat Exchanger Maintenance

ALPHA PLUS HARDI NOVA
MM AA II NN TT EE NN AA NN CC EE
CHAPTER
55-
4
55-
33
-
44
EE NN GG II NN EE MM AA II NN TT EE NN AA NN CC EE
HHeeaatt eexxcchhaannggeerr cclleeaanniinngg
Use only cooling system protective liquid : reference TOTAL ORGANICOOL (See table of lubricants)
To prevent engine overheating (caused by sedimentation in the cooling system) do not mix with
other coolants
The amount of contamination in the cooling system depends on the spray
application. Frequency of cleaning must be increase in the case of dusty
environment
nt,
((11))
de
ti-
- Engine oil level
- Fuel level
CCoooollaanntt LLeevveell
- When the engine is cold, coolant level shoud be
above the mark on the sight glass
((11))
- Unscrew the filler cap
((22))
and fill up coolant up if
necessary
This chapter discribe operations maintenance on DEUTZ engine. Refer to the specific manual for the DEUTZ
engine for all further information
11
22
- Open the engine bonnet
- Blow out heat exchanger with compressed air.Be careful not to damage
the cooling fins
- Run the engine up to normal operating temperature to evaporate any
remaining water.