Figure 1
1. The measure is from center to center of the tubes. Referring to the above diagram
and confirm the place of the base plates. ENSURE THAT THE FOUNDATIONS IS
SQUARE.
2.Fix the base plate (No. L1/ L2 / R1) and Connecting pieces (No.15) by bolt (No. 16)
according to Figure 1.
Note: The connector (NO.15) please refer to NO.A & NO.B ,the Base plate for
inner arch frame please refer to NO.C & NO.D, the Base plate for corners please refer
to NO.E & NO.F as below:
To Next Page
Loading...
