HardWire HT-2 - Pedal Controls and Jacks; Interface Controls; Input;Output Connections; Foot Switch Details

3
What Does This Do?
1. Mode Button -Selectsthedisplaymode(NormalorStrobe)for
theTuningLEDArray.Themodesarelabeledbelowthelasttwo
LEDsoftheTuningLEDArray.
2. Input -Connectyourinstrumenthere.Thisjackenablesbattery
powertothepedalwhenconnected.Toprolongbatterylife,discon-
nectthecablefromtheInputjackwhennotinuse.Iftheoptional
HarmanPS200Rpowersupplyisused,cablescanremainconnected.
3. Foot Switch Release Pins -Thesetwopinsarespringloaded
hingesthatholdtheFootSwitchinplace.Seepage13forinforma-
tiononaccessingandchangingthebattery.
4. Foot Switch-TurnstheTuneronandoff.
5. Thru Output-Connectthisoutputtotheinputofyourampor
theinputofanotherpedalifyouwanttheoutputsignalfromyour
instrumenttobeaudiblewhenthetunerisenabled.