EasyManuals Logo

Harley Benton Powerplant User Manual

Harley Benton Powerplant
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Thomann GmbH • Hans-Thomann-Straße 1 • 96138 Burgebrach • www.thomann.de • info@thomann.de DocID: 402819_28.04.2021
EN
Quick Start Guide
This quick start guide contains important information on the safe operation of the
product. Read and follow the safety advice and instructions given. Retain the quick
start guide for future reference. If you pass the product on to others please include
this quick start guide.
PowerPlant Powerbank
Safety instructions
Intended use
This product is meant to be used for the mobile voltage supply of suitable devices.
Any other use or use under other operating conditions is considered to be improper
and may result in personal injury or property damage. No liability will be assumed for
damages resulting from improper use
Danger for children
Ensure that plastic bags, packaging, etc. are disposed of properly and are
not within reach of babies and young children. Choking hazard! Ensure
that children do not detach any small parts from the product. They could
swallow the pieces and choke!
Incorrect handling of lithium batteries can result in injury
In the event of a short circuit, overheating or mechanical damage, lithium batteries
can cause severe injuries.
When handled correctly and appropriately lithium batteries pose no risk.
Store lithium batteries in a cool, dry place, ideally in the original packaging.
Store lithium batteries away from heat sources (e.g. radiators or sunlight). Lithium
batteries are hermetically sealed. Never attempt to open a lithium battery.
If the battery housing is damaged small amounts of the electrolyte may leak out. If
this should happen, seal the lithium battery in airtight packaging and wipe up the
traces of electrolyte using absorbent paper towels. You must wear protective rub-
ber gloves when doing so. Clean your hands and the aected surface thoroughly
with cold water.
Never attempt to recharge non-rechargeable lithium batteries. When charging lit-
hium batteries you must use a suitable charging device intended for the purpose.
Before disposing of the device remove the lithium batteries. Protect used lithium
batteries against potential short circuits, e.g. by covering the poles with adhesive
tape.
Only use powder extinguishers or other suitable extinguishing agents to extingu-
ish a burning lithium battery.
Possible damage to lithium-ion batteries through incorrect storage
By deep discharge, lithium-ion batteries can be permanently damaged or lose
some of their capacity.
Before long breaks, charge the batteries to around 50 % of their capacity and then
switch o the device. Store the device at room temperature or cooler in an environ-
ment as dry as possible. If the batteries are stored for a longer period, recharge
them to 50 % every three months.
Fully charge the batteries only shortly before use at room temperature.
Where to use the product
Never use the product
in conditions of extreme temperature or humidity
in extremely dusty or dirty areas
at locations where the unit can become wet
General handling
To prevent damage, never use force when handling the product.
Never immerse the product in water. Just wipe it with a clean dry cloth. Do not
use liquid cleaners such as benzene, thinners or ammable cleaning agents.
Features
Mobile voltage supply for pedals, amps, cell phones etc.
Automatic overload protection when charging
Automatic shuto on short circuits
Reminds timely on due recharging
Charge indicator via 4 LEDs, LED spot light
Scope of delivery
31×USB charging cable
32×60cm DC 9V cable for eects devices
31×10cm polarity DC adapter cable for eects devices
31×daisy-chain DC cable with 5 connectors for eects devices
Operating elements
ö#$% ö
ö 9V supply outlet for eects devices
# 5V
supply outlet, USB format
$ LED spot light
% Micro USB port to recharge the unit
& 9V voltage indicator, blue
ä 4-segment charge status indicator
( On / O button
PowerPlant Powerbank
(
& '

Other manuals for Harley Benton Powerplant

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Harley Benton Powerplant and is the answer not in the manual?

Harley Benton Powerplant Specifications

General IconGeneral
Total Output Current2000 mA
Input Voltage100-240V AC
Short Circuit ProtectionYes
LED IndicatorYes
Frequency50/60 Hz
Input Frequency50/60 Hz
Output Voltage9V DC
PolarityCentre Negative