TM
9-879
54
TRANSMISSrON
or not shifter rod is correctly adjusted,
so that when
hand
lever
is
moved to any gear position
in
tank
shifter
guide, transmission
lever
moves to
the
proper
position
to
fully
engage
shifter clutch dogs
and
shifter cam
spring plunger
in
cam-locsting notch (inside
trans-
mission).
RAPD
310229'
figure
32~Adjustlng Gear
Shifter
Rod
c.
Adjusting
Gear Shifter Control Linkage (fig.
32).
(1)
Set hand lever in
"N"
(neutral) position in shifter
guide.
(2)
Remove nut and
bolt
to disconnect shifter rod
from hand
lever.
(3)
With
slight backward and forward movement of shifter rod,
carefully
"feel"
transmission lever
into
exact
position where shifter
cam spring
plunger (inside transmission)
seats
fully in
cam-locating
notch.
(4)
Next,
see
that
hand
lever is
in exact "N" (neutral)
position
in
tank
shifter guide.
97
To Next Page