Harman Kardon DRIVE + PLAY [HK-DP1EU] - Wiring Diagram; Direct Connection of the 12-Volt Power Harness

Direct Connection of the 12-Volt Power Harness With
In-Line Fuse Holder
Use this method when you want a direct connection to the
vehicle’s electrical system. Leaving the in-line fuse holder intact,
cut the cigarette lighter plug from the cord and strip about
4 inches of the thick, black insulation away from the three wires
inside.
Connect the red wire inside to the vehicle’s ACC (accessory
circuit). Connect the yellow wire to the vehicle’s constant 12V
power wire, and connect the black wire to the vehicle’s ground
circuit. The best place to make those connections is in the harness
that provides power and ground to the vehicle’s radio.
IMPORTANT: Replace the in-line fuse only with one of the
same type and rating.
INSTALLATION 5
INSTALLATION
Auxiliary
Device
(optional)
Third-Party
CD Changer
Interface
(optional)
Text Display
BackSide
+12V = yellow
CD Changer L/R In
Aux. L/R In
Antenna In
2A Fuse
2A Fuse
Cut and
Strip Cable
ACC = red
GND = black
Electronics Enclosure
Antenna Cable
(disconnect from
Head Unit/Radio)
Head Unit/Radio
or
or
or
or
Cell Phone,
Satellite Radio, etc.
iPod Cable
3.5mm Stereo Cable
(not included)
Line Out Cable
Wired
FM Adapter
Wireless
FM Transmitter
(Only available in
selected countries)
12-Volt
Accessory
Power Cable
iPod
Control Knob
Direct Power
Connection
Removable
Power Connection
Wiring Diagram
Tip = LEFT
Sleeve = GROUND
3.5mm Stereo
Mini-Plug Cable
RIGHT = Ring
Audio Input/Output Jacks