Harman Kardon GPS GPS-810 - Installing the Mounting Bracket

Install the Mounting Bracket
FOR WINDSHIELD MOUNTING:
1. Hold the mounting
bracket’s base against
the windshield.
2. Push the mounting
bracket lever towards
the base to lock the
bracket to the wind-
shield.
FOR DASHBOARD MOUNTING:
1. Clean the dashboard
mounting location
with the supplied
alcohol pad.
2. Peel the mounting
base adhesive cover-
ing.
3. Attach the mounting
base to the mount-
ing location.
4. Hold the mounting
bracket’s base against
the mounting base.
5. Push the mounting
bracket lever towards
the base to lock the
bracket to the dash-
board.
ATTACHING THE GPS-810 TO THE BRACKET
1. Fit the bottom mounting
slot into the bracket cradle.
2. Snap the rear mounting slot
into the bracket cradle.
Make sure that the unit is
securely connected to the
bracket so it will receive
power from the car charger.
To unlock and remove the
unit, press the lever on the
bottom of the cradle up.
User Manual
32
ediug +yalp
™
GPS-810
1. Clean Mounting
Location on
Dashboard
3. Attach Mounting
Base to Dashboard
4. Attach Bracket
to Mounting Base
2. Peel Covering
From Mounting
Base Adhesive
5. Push Lever
Towards Base
to Lock
1. Fit Bottom
Mounting Slot
Into Cradle
2. Snap Rear
Mounting Slots
Into Cradle
1. Hold Base
Against
Windshield
2. Push Lever
Towards Base
to Lock