Need help?Do you have a question about the Harman Kardon HK570I and is the answer not in the manual?
Connect turntable signal cables to PHONO INPUT (34) and ground wire to GND (33).
Connect tape deck outputs to TAPE 1/2 INPUT (36/38) and inputs to TAPE 1/2 OUTPUT (37/39).
Connect 'high level' output equipment like tuners or TV audio to AUXILIARY INPUTS (35).
Use two-conductor wire (18-14 gauge) to connect speakers to terminals (40/41), observing polarity.
Use SPEAKER 1 (4) and SPEAKER 2 (5) switches. Headphones can be used with speakers.
Depress PHONO (14), activate turntable, adjust VOLUME (22). Check connections if hum occurs.
General| Power output | 40 watts per channel into 8Ω (stereo) |
|---|---|
| Frequency response | 20 Hz to 20 kHz |
| Total harmonic distortion | 0.09% |
| Input sensitivity | 2.5mV (MM), 150mV (line) |
| Tuning range | FM: 87.5 to 108 MHz |
| Signal to noise ratio | 95 dB (line) |
To Next Page
