Harman Kardon HKTS 9 - Connecting via Receiver Line Outputs

PL0004-01001
LEFT
LFE SUB
OUTPUT
TRIGGER
OUT
+ – + –
+ –
+ –
+ –
+ –
+ –
RIGHT
SURROUNDFRONT CENTER
8
8 9
ENGLISH
If your preamp/processor or another audio/video component has a trigger voltage
connection that supplies between 3 and 30V (AC or DC), connect it to the HKTS200SUB’s
External Trigger Input Connector
4
. If the component’s trigger voltage connection has
a 3.5mm mini jack you can use the supplied combination LFE/trigger cable to make the
connection.
NOTE: Please do not connect the subwoofer ON/OFF trigger cable to the Remote Control
Output (IR Out) of your home cinema system or surround receiver. This could lead to
malfunction.
Connecting to a Trigger Voltage Source
Receiver
Subwoofer
Trigger Cable
(Black Ends)