Harman Kardon PM635I - Page 4

CONNECTIONS
Turntable (MM)
OUTPUT
"aS «©
ML vor ©)
Cassette Tape Deck
Speaker System 1
Right channe Left channel
O=0 lol lemme TE
HE
TE] 11 5 500 o
ce = BI KO)
oa i sah
Compact Disc Player
TV Tuner
Connecting Other Components
Carefully connect the plugs to the left and right channel jacks.
Push the plugs in all the way. Poor setting of the plugs tends
to cause hum or intermittent sound and may damage the
speakers.
NOTE: While you are connecting this unit to the rest of your
high fidelity system, please unplug the power cord, discon-
necting not only this unit but all the components, from the
AC outlet.
Do not interwind the connection wires with the power cord.
If interwound, the sound quality may be degraded.
AC Convenience Receptacles
This unit is provided with two AC convenience receptacles
on the rear panel for supplying power to a tuner, turntable,
tape deck or other low power component. The receptacles
have a power capacity of 180 watts each. Check the
component's owner's manual to find its power requirement.
SWITCHED: The power to this receptacle is turned on and
off by this unit's power switch.
UNSWITCHED: The power to this receptacle is independent
of this unit's power switch.
NOTE: In some countries, these AC convenience receptacles
are not available.
Video Component or
ef | To wall
OIL outlet
so>
Open Real Tape Right channel Left channel
Deck Speaker System 2
Connecting Speakers
Connect the speaker wires carefully to the speaker terminals
on the rear panel so as not to mistake the left and the right
channels or reverse the speaker polarities (+ and -).
Use sufficiently thick wire (18 gauge for short lengths, 16-12
gauge for longer lengths). It is recommended to use
color-coded wire for easy polarity identification. Speaker wires
should be as short as possible, and the left and the right channel
wires should be the same length.
1. Remove about 20mm (3/4 inch)
of insulation from the end of each
wire and twist the strands of each
end.
2. After making sure of the correct
channel and polarity, loosen the
SPEAKER SYSTEM termina! knob
and insert the conductor directly
into the recess at the upper-right
of the terminal. Then tighten the
terminal knob, and the end of
speaker wire is automatically
wound around the terminal.
CAUTION: Two speaker systems can be connected to this
unit. The minimum speaker impedance should be 4 Ohm when
only one speaker system is connected. When two speaker
systems are connected, care should be taken that net impe-
dance does not become less than 4 Ohm.