Harman Kardon The Bridge III - Installation and Setup; Connecting the Docking Station; Selecting the Correct Dock Adapter

3
ENGLISH
INSTALLATION
INSTALLING
With only a single cable connection, The Bridge III is
easy to connect to your Harman Kardon product.
Step One: Turn off the Harman Kardon The Bridge
)))READYPRODUCTUSINGITSMAINPOWERSWITCH
Step Two: Holding the cable with the wider part of
the connector at the bottom, gently squeeze the tabs
on each side as you insert it into the connector on the
REARPANELOFTHE(ARMAN+ARDONPRODUCT3EE&IGURE
&IGUREn4HE"RIDGE)))CONNECTOR
Step Three: Place the black insert in The Bridge III,
MAKINGSURETOPUSHITALLTHEWAYDOWN3EE&IGURE
NOTE:$ONOTPLACEANI0ODORI0HONEIN4HE"RIDGE
III unless both the black insert and a dock adapter
AREINSTALLED/THERWISETHEI0ODORI0HONEWILLNOT
connect properly, and both it and the Bridge III may
SUSTAINDAMAGETHATISNOTCOVEREDBYTHEWARRANTY
Step Five
Step Four
Step Three
Step Four:,OCATETHEDOCKADAPTERTHATWAS
included with your iPod or iPhone, or select one of the
included clear dock adapters by referring to Table 1. If
your iPod or iPhone does not appear in Table 1 and did
NOTINCLUDEANADAPTERCONTACT!PPLE)NCTOPURCHASE
one.
Place the adapter in The Bridge III insert, as shown
IN&IGURE
Step Five:2EMOVETHEI0ODORI0HONEFROMANY
case, and dock it in The Bridge III, as shown in
&IGURE
Table 1 – Select the Correct The Bridge III Insert
&IGUREn
$OCKINGANI0ODOR
iPhone in The Bridge III
The Bridge III Insert iPod Model
.!./ I0ODNANOSTANDNDGENERATION
'6)$%/'" I0ODTHGENERATION'"'"ANDI0ODCLASSIC1'"
'6)$%/'" I0ODTHGENERATION'"ANDI0ODCLASSIC'"
1 I0ODNANORDANDTHGENERATION
 I0ODTOUCHnINSTALLLARGEBUMPER
 I0HONEANDI0HONE'nINSTALLSMALLBUMPER