Harman Stove Company Accentra 2 User Manual

SAFETY NOTICE
PLEASE READ THIS ENTIRE MANUAL BEFORE YOU INSTALL AND USE YOUR NEW ROOM HEATER. FAILURE TO
FOLLOW INSTRUCTIONS MAY RESULT IN PROPERTY DAMAGE, BODILY INJURY, OR EVEN DEATH.
FOR USE IN THE U.S. AND CANADA. SUITABLE FOR INSTALLATION IN MOBILE HOMES
IF THIS HARMAN ACCENTRA PELLET STOVE IS NOT PROPERLY INSTALLED, A HOUSEFIRE MAY RESULT. FOR
YOUR SAFETY, FOLLOW INSTALLATION DIRECTIONS.
CONTACT LOCAL BUILDING OR FIRE OFFICIALS ABOUT RESTRICTIONSAND INSTALLATION INSPECTION
REQUIREMENTS IN YOUR AREA.
CONTACT YOUR LOCAL AUTHORITY (SUCH AS MUNICIPAL BUILDING DEPARTMENT, FIRE DEPARTMENT, FIRE
PREVENTION BUREAU, ETC.) TO DETERMINE THE NEED FOR A PERMIT.
CETTE GUIDE D'UTILISATION EST DISPONIBLE EN FRANCAIS. CHEZ VOTRE CONCESSIONNAIRE DE HARMAN STOVE
COMPANY.
SAVE THESE INSTRUCTIONS.
The Harman Accentra-2 Pellet Stove
Installation & Operating Manual
R4
“Ce manuel est disponible en Français sur demande”
Evaluation notes were added to the output document. To get rid of these notes, please order your copy of ePrint IV now.

Harman Stove Company Accentra 2 Specifications

General

Brand	Harman Stove Company
Model	Accentra 2
Category	Stove
Language	English

Summary

Safety Notice

Introduction to the Accentra Pellet Stove

Automatic Operation Modes

Room Temperature Mode

Operates based on desired room temperature, adjusting heat output automatically.

Stove Temperature Mode

Maintains a constant heat output regardless of room temperature.

Shut-Down Procedure

Instructions on how to properly turn off the pellet stove.

Automatic Start Up Procedure

Starting First Fire

Step-by-step guide for initiating the first burn cycle.

Manual Operation Modes

Manual Room Temperature Mode

Manual control of heat output based on target room temperature.

Manual Stove Temperature Mode

Manual control for a larger viewing fire with less heat into the room.

Manual Start Up Procedure

Manual First Fire Start

Step-by-step guide for manual ignition and startup.

ESP Control System

Status Light Error Codes

Explains status light indicators and diagnostic error messages.

Installation Requirements

Floor Protection Requirements

Specifies non-combustible floor protection needed for installation.

Combustible Clearances

Details minimum safe distances from combustible materials.

Installation Adjustments

Leveling Feet Adjustment

Instructions for adjusting the rubber pad leveling feet for stability.

Mobile Home Installation

Mobile Home Safety Precautions

Specific safety warnings for mobile home installations.

Low Draft Voltage Adjustment

Draft Meter Adjustment Location

Identifies the port for adjusting low draft voltage.

Component Installation

Room Sensor Installation

Guidance on installing the room sensor for temperature control.

Rear Shield Installation

Instructions for installing the rear shields for protection.

Venting System Setup

Vent Pipe Specifications

Details approved pellet vent pipe types and installation.

Outside Air Connection

Information on connecting an outside air supply.

Venting Configurations

Preferred Venting Method 1

Details the first recommended venting configuration for optimal performance.

Preferred Venting Method 2

Details the second recommended venting configuration for optimal performance.

Venting into Existing Chimneys

Installing into Standard Chimney

Guidance for venting into a standard chimney.

Installing into Fireplace Chimney

Guidance for venting into a fireplace chimney.

Venting into Existing Chimneys (Canada/US)

Fireplace Chimney Venting

Requirements for venting into fireplace chimneys in Canada and US.

Standard Chimney Venting

Requirements for venting into standard chimneys in Canada and US.

Ceiling Venting and Flue Configuration

Installing Through Ceiling Vent

Instructions for venting the unit through the ceiling.

Minimum Flue Vent Configuration

Recommended configuration for flue venting.

Vent Termination Requirements

Vent Terminal Placement Rules

Specifies rules for placing the vent terminal relative to buildings and property.

Combustible Wall Passage

Guidelines for passing the vent through combustible walls.

Cleaning the View Door Glass

Cleaning Internal Components

Feeder Chamber Cleaning

Procedure for cleaning the feeder chamber of pellet fines.

Cleaning Internal Components (Continued)

Burn Pot Maintenance

Burn Pot Cleaning Procedure

Detailed steps for cleaning and maintaining the burn pot.

Component Locations and Safety Devices

Safety Devices Overview

Explains the various safety devices integrated into the pellet stove.

Troubleshooting Common Issues

Helpful Maintenance and Fuel Tips

Provides practical advice for stove upkeep and fuel selection.

Fuel Type Considerations

Discusses different pellet fuel categories and their impact.

Technical Specifications

Accentra Wiring Diagram

Accentra Feeder Parts

Accentra Parts List

Harman Gold Warranty Information