Read these instructions carefully before you attempt to install
or operate the Advance. Failure to do so may result in dam-
age to property or personal injury and may void the product
warranty.
Consult with your local building code agency and insurance
representative before you begin your installation to ensure
compliance with local codes, including the need for permits
and follow-up inspections.
Several issues must be addressed when selecting a suitable
location for your Advance Pellet Stove. Observing required
clearances to combustible materials, the proximity to a safe
chimney or venting system, and the accessibility of electrical
supply must all be considered. In addition, selecting a location
that takes advantage of the building's natural air ow is also
desirable to maximize the heating effectiveness of the heater.
In many cases, this is a central location within the building.
Place the stove on a noncombustible oor protector that ex-
tends 6 inches to the front, 6 inches to the sides and 1 inch
to the rear of the stove. (Fig. 8.)
Place the stove away from combustible walls at least as far
as shown in gures 6, and 7. The clearance to a ceiling above
the appliance is 24" (61cm).
Note that the clearances shown are minimum for safety, but
do not leave much room for access when cleaning or servicing.
Please take this into account when placing the stove.
When installing this stove in a mobile home several require-
ments must be followed:
1. The unit must be bolted to the oor. This can be done with
1/4" lag screws through the 2 holes in the base plate shown
in Fig. 11, Page 10.
2. The unit must also be connected to outside air. See page 14.
3. Floor protection and clearances must be followed as shown
to right.
4. Unit must be grounded to the metal frame of the mobile
home.
5. The unit may not be installed in a bedroom.
Installation and repair of this stove should be done by a
qualied service person. The appliance should be inspected
before use and at least annually by a qualied service person.
Frequent cleaning will be required. It is imperative that control
compartments, burners, and circulating air passageways of
the stove be kept clean.
Fig.6
Fig.7
7"
7"
1"
10"
6"
(152mm)
6" (152mm)
Fig.8
FLOOR
PROTECTOR
6"
(152mm)
Floor protection measured from window opening.
1"
To Next Page
Loading...
